Creates two-way extrusion for polygons to turn flat surface into solid shape.
Extrusion strength might be controlled with Fields falloff.
Implemented as Generator and Modifier.
Modifier supports Restriction tag.
Enforces to rebuild on each timeline's frame.
Thickness depth size.
Use this setting to define the number of extrusion steps.
Defines balance of solid shape towards original polygon normals direction.
Value of 50% would have equal distance between start & end caps relative to original surface.
Subdivide solid shape caps.
Caps are not subdivided.
Caps are subdivided linear.
Caps are subdivided smoothly over surface and boundaries.
Caps are subdivided smoothly over surface, but keep boundaries edgy.
Number of subdivision steps that should take place. The polygon or point count will increase exponentially with each step. Should be careful increasing the number of steps.
Especially in Iron mode.
Applicable for Iron mode only.
The Percent value defines the strength of smoothing. A value of 0% results in no smoothing at all, while a value of 100% produces maximum smoothing.
Defines the maximum angle the surfaces can have to each other while still maintaining a hard edge.
If this angle is smaller than the defined value, the edge will be rounded.
Applicable for Iron mode only.
Defines smoothing iterations count.
Creates Start Cap Polygon Selection tag.
Creates End Cap Polygon Selection tag.
Creates Shell side Polygon Selection tag.
Creates Depth weight map Vertex Map tag.
Disabled — gradient comes from the start to the end.
Enabled — gradient comes from the end to the start.
Enabled — caps boundaries would have broken phong edges to have sharper look.
Enabled — solid shape normals would be inverted, i.e. inwards.
Fields falloff to control Depth Adder's thickness.